FM-16-9, Fiber Optical Multiplexer
Specification:
| Optical Fiber Interface | Source: MLM Laser Wavelength: 1310 ± 50 nm, 1550 ± 40 nm Power: -26 or -8 dBm Receiver Sensitivity: -38 dBm at BER < 10-10 50 Km reach System Gain: 30 dB Line Code: Scrambled NRZ Detector Type: PIN-FET Fiber Type: Single mode Protection: Optional 1+1 APS NOTE: Longer or shorter, 15 to 120Km, on special order. |
| E1 Line Interface | Number of E1 lines: Up to 16 Line Rate: 2.048 Mbps ± 50 ppm Line Code: HDB3 Line Impedance: 120W twisted pair, 75W for BNC Connector: RJ48C, BNC, DB37 Output Signal: ITU G.703 NOTE: Other Impedance, 100W and 110W, on special order. |
| Bridge | 10/ 100 Mbps half/ full duplex ethernet bridging and 100 Mbps operation on the HDLC port ANSI/ IEEE Std. 802.1D MAC Bridging capabilities (without spanning tree algorithm) Automatic MAC table learning and aging Support VLAN and extended Ethernet frame support |
| 4-RS232 | Connector: DB25 Data Rate: Up to 64Kbps async |
| V.35 | Port Number: 4 ports Data Rate: Nx64kbps (N=1~32) Connector: M34 Clock Mode: External, Internal, Received (Selectable); DTE/DCE programmable |
| SNMP Port | Connector: RJ45 at rear panel Protocol: Telnet |
| Console | Connector: DB9 at front panel Electrical: RS232 interface Protocol: Menu driven VT-100 terminal Baud Rate: 9600, 19200, 38400, 57600, 115200 |
| Switches and Contacts | Power, Alarm Cut-Off, Reset, A & B dip switches for command setup, and ENTER for command execute. Major and Minor alarm contact closures, DB9F connector. |
| Indicators | Power, Major & Minor Alarms, System Fail, Abnormal Operation, Electrical Failure. Receive signal indications for all E1s. Local optical signal receive indication, working and protection. Remote optical signal receive indication, working and protection. Laser operation, working and protection. Command execution complete. |
| Physical/Electrical | Dimensions for 1U: 44 x 432 x 255 mm (HxWxD) Dimensions for 2U: 88 x 432 x 255 mm (HxWxD) Dimensions for 3U: 132 x 432 x 255 mm (HxWxD) Mounting: Stand-alone, 19 or 23 inch rack mount Power Source: -42 to -60 Vdc or 100 to 240 Vac, 50/ 60 Hz Power Protection: Optional 1+1 APS Power Consumption: < 30 W Temperature Range: 0oC to 50oC Humidity: 0% — 95% RH (non-condensing) |
| Diagnostics Test | Optical Fiber: Local and remote loopbacks E1 Lines: Local and remote loopbacks |
| Applications: | |
